1. Semi-vortex urethane Rubber impeller with agitator suspends solids and allows for pumping of sand and stringy material.

2. Hightly efficient, continuous duty air filled, copper wound motor with class B, insulation minimizes the cost of operation

3. Built in thermal protection prevents motor failure due to overloading, accidental run-dry and single phasing in three phase units.

4. Double inside mechanical seals with silicon carbide faces (both top and bottom) running in an oil filled chamber provide for one the most durable seal designs available.

5. Double shielded, permanently lubricated, high temperature C3 ball bearings rated for a B-10 life or 60,000 hours provide for extend operational life.

The motor is 1/2hp. It runs on standard household current. It can pump between 15 and 50 gallons per minute. It can pump up to 34' high. The power cord is about 16' long.

It can be used for the following applications:

1. Residential, commercial, industrial dewatering and site drainage.

2. Decorative waterfalls and fountains.

3. Raw water supply from lakes or rivers.

4. Sediment removal from small sumps of basins.

The body of the pump is cast iron and the base is plastic.